Support at 14:04, 10 April 2012

Support — Tue, 10 Apr 2012 14:04:33 GMT

← Older revision		Revision as of 14:04, 10 April 2012
Line 5:		Line 5:
	</div>		</div>

-	This example shows how to use the DAC to generate a sine wave. The signal output is shown below. In integer format the 10-bit outputs go between 0 and 1023 (0x03FF) for the range 0.00V to 3.30V in steps of 3.22 mV. Op-amps or other alternatives should be used to implement scaling and isolation. The first UART, which is connected to the COM1 on the Lincoln microcontroller board, is configured for 115,200 bits per second, and 8-n-1 mode. When the program is started a message will be printed to the terminal.	+	This example shows how to use the DAC to generate a sine wave. The signal output is shown below. In integer format the 10-bit outputs go between 0 and 1023 (0x03FF) for the range 0.00V to 3.30V in steps of 3.22 mV. Op-amps or other alternatives should be used to implement scaling and isolation.

	[[Image:Lincoln_dac_sine.png\|center\|]]		[[Image:Lincoln_dac_sine.png\|center\|]]
-
-
-	~~[[Image:Lincoln_dac_sine2.png\|center\|]]~~

Support: Created page with '==Compatibility [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60], [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60E]== The NXP LPC1769 microco…'

Support — Tue, 10 Apr 2012 14:02:49 GMT

Created page with '==Compatibility [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60], [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60E]== The NXP LPC1769 microco…'

New page

==Compatibility [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60], [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60E]==

The NXP LPC1769 microcontroller used in the Lincoln controller line supports one channel of 10-bit DAC that has an update rate of 1 MHz. The DAC signal is available on pin 7 on the following header:
[[Image:Lincoln-60-ADC.png|center|alt=Lincoln-60|frame|<div align="center">'''Lincoln: Analog to Digital connector pin out]]
</div>

This example shows how to use the DAC to generate a sine wave. The signal output is shown below. In integer format the 10-bit outputs go between 0 and 1023 (0x03FF) for the range 0.00V to 3.30V in steps of 3.22 mV. Op-amps or other alternatives should be used to implement scaling and isolation. The first UART, which is connected to the COM1 on the Lincoln microcontroller board, is configured for 115,200 bits per second, and 8-n-1 mode. When the program is started a message will be printed to the terminal.

[[Image:Lincoln_dac_sine.png|center|]]

[[Image:Lincoln_dac_sine2.png|center|]]

Lincoln DAC Sinewave Example - Revision history

Support at 14:04, 10 April 2012

Support: Created page with '==Compatibility [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60], [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60E]== The NXP LPC1769 microco…'