Bambino-210 Manual/Appendix A
From Manuals
(Difference between revisions)
(→Appendix A - Updating CMSIS-DAP Firmware) |
|||
| Line 1: | Line 1: | ||
[[Category: Bambino-210_Manual|08]] | [[Category: Bambino-210_Manual|08]] | ||
==Appendix A - Updating CMSIS-DAP Firmware== | ==Appendix A - Updating CMSIS-DAP Firmware== | ||
| - | * 1. Locate the updated CMSIS-DAP binary file | + | * 1. Locate the updated [[Bambino_Documentation#System Files - mbed|CMSIS-DAP binary file]] |
| - | * 2. Boot the MBED HDK into CRP DISABLED mode by shorting JP3 while connecting the | + | * 2. Boot the MBED HDK into CRP DISABLED mode by shorting JP3 while connecting the USB1 Cable. A [[Image:CRP_DISABLED.png]] drive should appear. [[Image:BAM210E_CRP_DISABLED.png|center]] |
* 3. Program the Interface firmware by deleting the firmware.bin file and copying the new binary to the CRP DISABLED disk. | * 3. Program the Interface firmware by deleting the firmware.bin file and copying the new binary to the CRP DISABLED disk. | ||
| - | * 4. Reboot the Interface by disconnecting and reconnecting the | + | * 4. Reboot the Interface by disconnecting and reconnecting the USB1 cable without JP3 shorted |
* 5. Verify that the MBED disk comes up | * 5. Verify that the MBED disk comes up | ||
* 6. Finished! | * 6. Finished! | ||
---- | ---- | ||
[[Bambino-210_Manual/References|PREVIOUS: References]] | [[Bambino-210_Manual/References|PREVIOUS: References]] | ||
Revision as of 12:58, 7 October 2014
Appendix A - Updating CMSIS-DAP Firmware
- 1. Locate the updated CMSIS-DAP binary file
- 2. Boot the MBED HDK into CRP DISABLED mode by shorting JP3 while connecting the USB1 Cable. A
drive should appear. 
- 3. Program the Interface firmware by deleting the firmware.bin file and copying the new binary to the CRP DISABLED disk.
- 4. Reboot the Interface by disconnecting and reconnecting the USB1 cable without JP3 shorted
- 5. Verify that the MBED disk comes up
- 6. Finished!
