Eagle ADC Example
From Manuals
(Created page with '=Analog to Digital Converter (ADC)= ==Compatibility[http://www.micromint.com/index.php/SBC/eagle-50.html Eagle50]==') |
|||
| (7 intermediate revisions not shown) | |||
| Line 1: | Line 1: | ||
=Analog to Digital Converter (ADC)= | =Analog to Digital Converter (ADC)= | ||
| - | ==Compatibility[http://www.micromint.com/index.php/SBC/eagle-50.html | + | ==Compatibility [http://www.micromint.com/index.php/SBC/eagle-50.html Eagle 50], [http://www.micromint.com/index.php/SBC/eagle-50.html 50E], [http://www.micromint.com/index.php/SBC/eagle-100.html 100]== |
| + | |||
| + | The TI LM3S microcontrollers used in the Eagle controller line support eight single ended or four differential 10-bit analog inputs with a sampling rate up to 500 kilo-samples/sec (kSPS). These signals are available in the following headers: | ||
| + | [[Image:Eagle_ADC.png|center|]] | ||
| + | This example shows you how to read voltages from the 8 ADC channels. The screen output is shown below. Note that the voltages are shown in both integer and floating point formats. In integer format the 10-bit values go between 0 and 1023 (0x03FF) for the range 0.00V to 3.00V resulting in an accuracy of +/- 1.465 mV. Note that voltages over 3V should not be applied to the ADC inputs as they could damage the microcontroller. Op-amps or other alternatives should be used to implement scaling and isolation. | ||
| + | [[Image:Eagle_ADC1.gif|center|]] | ||
Current revision as of 01:02, 20 June 2010
Analog to Digital Converter (ADC)
Compatibility Eagle 50, 50E, 100
The TI LM3S microcontrollers used in the Eagle controller line support eight single ended or four differential 10-bit analog inputs with a sampling rate up to 500 kilo-samples/sec (kSPS). These signals are available in the following headers:
This example shows you how to read voltages from the 8 ADC channels. The screen output is shown below. Note that the voltages are shown in both integer and floating point formats. In integer format the 10-bit values go between 0 and 1023 (0x03FF) for the range 0.00V to 3.00V resulting in an accuracy of +/- 1.465 mV. Note that voltages over 3V should not be applied to the ADC inputs as they could damage the microcontroller. Op-amps or other alternatives should be used to implement scaling and isolation.
