Lincoln raw Example
From Manuals
(Difference between revisions)
(Created page with '==Compatibility [http://www.micromint.com/index.php/SBC/lincoln60.html Lincoln 60E]== This example application demonstrates how to test EMAC driver with raw packet frame format …') |
|||
| Line 10: | Line 10: | ||
* 1. setting flag (in emactest.c): | * 1. setting flag (in emactest.c): | ||
| - | + | * TX_ONLY = 1 | |
| - | + | * BOUNCE_RX = 0 | |
* 2. Build example and burn into first board. | * 2. Build example and burn into first board. | ||
* 3. Setting flag: | * 3. Setting flag: | ||
| - | + | * TX_ONLY = 0 | |
| - | + | * BOUNCE_RX = 1 | |
* 4. Build example and burn into second board. | * 4. Build example and burn into second board. | ||
* 5. Connect the two boards together using a CAT5 cable. | * 5. Connect the two boards together using a CAT5 cable. | ||
Revision as of 15:54, 10 April 2012
Compatibility Lincoln 60E
This example application demonstrates how to test EMAC driver with raw packet frame format that is not related with any upper-layer (i.e. TCP/IP...). In order to run this example you will need the following equipment:
- 1. Two Lincoln 60Es
- 2. Two COM ports on a computer
- 3. One Cat5 cable
Please follow these steps to run the CAN example:
- 1. setting flag (in emactest.c):
* TX_ONLY = 1
* BOUNCE_RX = 0
- 2. Build example and burn into first board.
- 3. Setting flag:
* TX_ONLY = 0 * BOUNCE_RX = 1
- 4. Build example and burn into second board.
- 5. Connect the two boards together using a CAT5 cable.
- 6. Connect COM1 on the two Lincoln boards to COM ports on the computer.
- 7. Configure hardware and serial display as above instruction.
- 8. Hit reset button on two boards.
- 9. Wait for EMAC initilization completes on two board.
- 10. If ENABLE_WOL is enabled on board 'BOUNCE_RX' side, after initializing EMAC, it will enter sleep mode to be waked-up on LAN (WoL).
- 11. On 'TX_ONLY' side, hit User button to send a frame.
- 12. After receiving frame, 'BOUNCE_RX' side will wake-up and operate properly.
The following screen shots are of the RAW example in action.
