Lincoln DAC Sinewave Example

From Manuals

Compatibility Lincoln 60, Lincoln 60E

The NXP LPC1769 microcontroller used in the Lincoln controller line supports one channel of 10-bit DAC that has an update rate of 1 MHz. The DAC signal is available on pin 7 on the following header:

Lincoln: Analog to Digital connector pin out

This example shows how to use the DAC to generate a sine wave. The signal output is shown below. In integer format the 10-bit outputs go between 0 and 1023 (0x03FF) for the range 0.00V to 3.30V in steps of 3.22 mV. Op-amps or other alternatives should be used to implement scaling and isolation.