View source

[[Category: PRO050_Manual|2]]
==Screw Terminal Schematic==
The PRO050 board has a footprint for a 12 position screw terminal (T1). It has a pitch of 0.15 inches (3.81mm). Connections for prototyping can be made on PT1. The schematic for the screw terminals is below in Figure 7.
 
[[Image:Pro050-screw-terminal.png|center|alt=PRO050|frame|<div align="center">'''Screw Terminal Schematic]]
  </div>
==Pushbuttons Schematic==
The PRO050 board has footprints for two normally open pushbuttons (S1 & S2). Connections for prototyping S1 can be made on PS1. Connections for prototyping S2 can be made on PS2. The schematic for the pushbuttons is below in Figure 8.
 
[[Image:Pro050-pushbutton.png|center|alt=PRO050|frame|<div align="center">'''Pushbutton Schematic]]
  </div>

==RJ45 Schematic==
The PRO050 board has a footprint for a RJ45 jack (J1). Connections for prototyping with the RJ45 can be made on P1. The schematic for the RJ45 and top view connector diagram is below in Figure 9.
 
[[Image:Pro050-rj45.png|center|alt=PRO050|frame|<div align="center">'''RJ45 Schematic]]
  </div>


==2 x 3 Jumper Schematic==
The PRO050 board has a footprint for a 2 x 3 jumper (JP1). Connections for prototyping the 2 x 3 jumper can be made on P1A and P1B. The schematic for the 2 x 3 jumper is below in Figure 9.
 
[[Image:Pro050-jumper.png|center|alt=PRO050|frame|<div align="center">'''Jumper Schematic]]
  </div>

----
[[PRO050_Manual/Eagle_50_Connections|NEXT: Eagle 50 Connections]]

[[PRO050_Manual/Introduction|PREVIOUS: Introduction]]